<table id="e3esn"><option id="e3esn"></option></table>
  • <td id="e3esn"><option id="e3esn"></option></td>
    <p id="e3esn"></p>
  • <acronym id="e3esn"><label id="e3esn"></label></acronym><table id="e3esn"><option id="e3esn"></option></table>

      <table id="e3esn"></table>

      歡迎訪問合肥通用機械研究院!
      聯系電話:韓工(15395150883)
      (0551-65335570)
      水射流清洗產品
      水射流清洗產品
      機械密封產品
      風機產品
      泵產品
      德國KAMAT高壓泵
      儲油罐機械清洗成套設備 當前位置:首頁 > 水射流清洗產品 > 儲油罐機械清洗成套設備
       
       
      TankCleaning
      來源: 發布時間:2019/11/15 10:14:09 發布人:

      Crude oil tank cleaning Equipment


      1、Crude oil tank cleaning equipment working principal introduction

      1.1 Working Principal

      At first, using the temporary pipes connect the 150,000m3 crude oil tank or smaller and the equipments to be a closed loop cleaning system . after that, use the same oil as the tank storage to broke the oil sludge. when the sludge is broken, to become liquid and small, it will be pumped out, and be separated、recycled, when most sludge and oil is pumped out, than, using hot water to clean the tank, at last, the tank will be cleaned up. This closed process is called crude oil tank cleaning technology.


      1.2 technological process

      Bottom oil transfer→ inject Nitrogen→ oil cleaning→hot water cleaning→open manhole/ventilate→clear up


      2、Product oil storage tank cleaning system working principal introduction

      2.1 working principal

      At first, using the temporary pipes connect the 50,000m3 refined oil tank or smaller and the equipments to be a closed loop cleaning system . after that,  using hot water to clean the tank, the oil /water will be pumped out, and be separated、recycled , at last, the tank will be cleaned up. This closed process is called refined oil tank cleaning technology.



      2.2 technological Process

      Equipment installation→inject Nitrogen→hot water cleaning→open manhole/ventilate→clear up


      3、Equipment introduction

      The GM tank cleaning system is used for cleaning the 1,000 m3-150,000 m3 crude oil tank and product oil tank.

      3.1 Equipment composition

      Cleaning /recycling module Vertical Spray Guns Side wall spray guns Nitrogen generator skimming module Tube & Pipe Assy



      Cleaning /recycling module

      The cleaning /recycling module include recovery pump unit、ejecting pump unit、vacuum pump unit and O2 monitor. All of these units integrate in a open type container.



      Tube & Pipe Assy: diaphragm pump、switch box、cable、air compressor、filter、pipes、valves, and so on.


      3.2 Technical specifications

      No

      name

      type

      GM-L

      GM-M

      GM-S

      Rang of application

      150,000 m3and smaller crude oil tank

      50,000 m3and smaller crude/product oil tank

      30,000 m3and smaller crude/product oil tank

      1

      Cleaning /recycling module

      flow

      180m3/h

      120m3/h

      80m3/h

      vacuum draw

      230m3/h

      165m3/h

      detection object

      O2、 flammable gas

      detecting point

      6 points

      4-6 points

      power

      155 kW

      115kW

      95kW

      dimension

      7m×2.3m×2.7m

      6.5m×2.3m×2.5m

      6.5m×2.3m×2.5m

      2

      Vertical Spray Gun

      flow

      40m3/h~80m3/hADJ

      pressure

      0.5MPa~0.7MPa

      3

      Side wall spray gun

      flow

      /

      40m3/h~90m3/hADJ

      pressure

      /

      0.5MPa~0.7MPa

      4

      Nitrogen generator

      generation rate

      300m3/h

      200m3/h

      purity

      99%VOL

      5

      Skimming

      module

      dimension

      7m×2.3m×2.6m

      6m×2.3m×2.6m

      volume

      20m3

      15m3

      6

      Diaphragm pump

      /

      flow:24m3/h, pressure:0.6MPa

      7

      Switch box

      /

      400A,EXDIIBT4,IP55, leakage protection

      8

      Cable

      /

      Three phase/anti-flaming/wear resistant

      9

      Air compressor

      /

      EXDIIBT4,IP55

      10

      Filter

      /

      Double type DN 600,bear pressure 1.6MPa,quick-open type

      11

      Pipe

      /

      bear pressure 1.6MPa, static conductivity

      3.3 Oil and Solid separator

      The oil and solid separator consists of pre-treatment system、feed pump、centrifugal machine、chemical dosing system 、screw conveyer、 fuel delivery pump and so on, fit for separating the solid、water and oil .



      oil and solid separation effect


      4、technical advantage

      (1) Safety: Explosion proof design, the nitrogen generator is the safety guarantee.

      (2) Efficiency: all mechanical work, 24 hours continue working, no person entry the tank in cleaning process.

      (3) Environmental friendliness: fully closed pipelining operations, no oil leakage, no pollution.

      (4) Efficiency: oil/water separator make the water can be recycled.

      (5) Professional: more than 200 spray guns be used in cleaning tank, our oil tank cleaning system have cleaned more than 200 tanks for petroleum/Sinopec/National oil storage base in China and southeast Asia customer .

      (6) Technological Achievements: the oil tank cleaning system has our own many invention patents, won “China machinery industry science and technology first prize” , and set a machinery industry standard JB/T 13138-2017.

      5、Engineering Projects

      The GM large oil storage tank cleaning equipments have been used to clean many big tanks in Xinjiang province/Gansu province/Zhejiang province/Sichuan province/Xian province/Beijing/Tianjin and in Southeast Asia, the good cleaning effect get the customers high praise.





      公司地址:合肥市高新區天湖路29號(合肥通用機械研究院有限公司 新區) 郵編:230031
      電話:0551-65335504 65335570 65335573 郵箱:13966779237@163.com
      版權所有:合肥通用環境控制技術有限責任公司 Copyright@ 2006-2019 All Rights Reserved 皖ICP備05012209號-3 站長統計 技術支持:安徽三戶網絡
      玩弄丰满奶水的女邻居

      <table id="e3esn"><option id="e3esn"></option></table>
    1. <td id="e3esn"><option id="e3esn"></option></td>
      <p id="e3esn"></p>
    2. <acronym id="e3esn"><label id="e3esn"></label></acronym><table id="e3esn"><option id="e3esn"></option></table>

        <table id="e3esn"></table>